Clear SUP Rail Saver RSPro

 45.00 IVA incluído

Highest quality Stand Up Paddle board rail protection in the market

– 2 strips with 191cm (6’3″) x 6,3cm (2″1/2)
– Clear, translucid, with RSPro logo at the side in silver color for a perfect match to any board colors.
– UV resistant and perfectly crystaline adhesive.
– Super-easy installation. Allows repositioning while installing and easy adaptation to difficult áreas.
– Semi-rigid 380 micron PVC lenticular pattern surface for high impact and abrasion resistance with the minimum weight
– Zero drag.

Video

Clear SUP Rail Saver RSPro

Clear SUP Rail Saver RSPro TIPS for a perfect installation:

Don’t install it on a cold environment.

We recommend to install it at room temperature. Below 20ºC (68F) the material and glue tend to get rigid, so it would make the installation more difficult.

If you can’t do it at room temperature above that temperature, use a hairdryer or heat gun to apply a gentle heat over the rail protection before, during and after installation.

Unroll the rail protection bands and place on at each side of the board.

Mark with a pencil the center of the rail protection band.

Before removing the backing, place the center of the rail protection band at the center of the board rail and extend it to the nose, mark the board with a pencil where the start of the rail protection band should be. Now you have the perfect placing longitudinally.

Start peeling the front side of the rail protection band and start sticking it where you marked the board and on the edge of the board rail (this is the more external part of the board, and where all impacts will take place).

Follow the board rail edge until the end.

Clear SUP Rail Saver

If your board coating/painting is weak (usually the case on extremely expensive and on extremely cheap boards), or if you prefer to play around with the rail protection band until you find the perfect spot, spray some clean water over the rail of your board.

It will allow you to move the rail protection band, and once placed, remove excess water with a squeegee or similar (example video). Rest of the water will evaporate by itself after some hours.

We recommend to wait for 6 hours before going to the water.

If you need to remove it, we advice to apply some heat with a hairdryer or heatgun to soft the adhesive and to make it easier to remove.

 

Também pode gostar…

  • HexaTraction Board Grip RSPro
  • Xtreme SUP rail saver

    Xtreme SUP Rail Saver RSPro

     39.00 IVA incluído Adicionar
Shopping Cart
Scroll to Top